Digital Waterbed Heaters - Touch Temp
From $79.95
- Certified to Underwriter's Laboratories for Waterbed Heaters Standards
- For Wood Frame Waterbeds
- 18 Gauge power cord - 72" long
- 32-guage Nickel/Copper flexible circuitry
- Larger Pad with 64-guage Thermal Fused Duraflex® Vinyl
- Premier Grey Control Base
- State-of-the-art Ultra sensitive electronic control that holds the temperature to + or - 1/8 degree of set point. Insures consistent and accurate temperture sensing and readout
- 5 year Limited Warranty
- Mylar Encased Circuitry
- Red Digital Readout
- Heater Pad Size 13 x 35.5
- 300 Watt for hardside waterbeds
• Additional Information:
In some colder areas a single 300 watt heater may not be able to maintain a temperature above 90 degrees in some waterbeds. This effect is most noticeable in king size full motion waterbed mattresses and mattresses with only a few fiber layers.
If you need a heat setting over 90 degrees two heaters are recommended if you have a king size mattress with no fiber or few fiber layers.
Installation Instructions for This Heater
Is this a Winter Replacement? Waterbed Heaters are low wattage devices manufactured specifically to protect the bottom of your mattress. They typically have as much power as an ordinary light bulb. If you are replacing a heater in Winter, the waterbed heater will simply be unable to bring dozens of gallons of cool water up to temperature. You should partiallly drain the mattress and refill with warm water to give your waterbed heater a head start.